Brush Wall Plate Kit VCELINK

I really like the way these wall plates cleaned up the back of the TV area. No more cables hanging down and winding along the floor. Easy to install.

We hid our TV cables in the drywall from behind the TV down next to the outlet and these work great and look good. If you opt to go for just the the wall plates, make sure you measure the clearance in the middle of the bracket that you buy. The center of the wall plate that holds the bristles protrudes in back, and will not fit all brackets. Thats why it's easier just to buy this combo pack!

Good way to organize the exit of speaker wire from the walls. Use this to connect wires directly to a receiver rather than terminating the wires inside the wall on a wall plate and using another set of cables from the wall plate to connect to your A/V receiver. This leaves the look neat and clean.

I had ordered this product primarily for the faceplate. When installing, I used a Carlon low-voltage old work bracket that I had on hand, thinking that it was better because it was a name brand and available at your local home improvement store. After installing though, I found that the bracket was having a hard time with the 9 Ethernet cables and 1 RG-6 passing through it. It was twisting, with the unsecured corners flexing forward from the wall. Upon closer inspection, I noticed that the "securing wings" on the Carlon bracket differed from those on the VCELINK bracket. If you look at the VCELINK bracket, you'll see that the wings secure in the middle of the bracket, top and bottom, whereas the Carlon are on opposite corners. That slight difference in design kept the VCELINK bracket and faceplate completely tight and flush with the drywall, even with the heavy load, where the Carlon bracket could not. You can see the finished product in the photo. The Carlon would not have been as tight, all around the faceplate. What a nice surprise!

I got a new television and want to baby-proof it so it won't fall over on the grandchild.... I was able to install the mount and hide the cables using this product. Total install time was only about 1 hour. I recommend this for and easy and quick install!

I was a little nervous but it turned out super easy. Did not come with instructions but you could tell that the black brace was fitted into the wall and the longer of the two screws were to tighten the clips to the drywall. The smaller screws were for attaching the front plate. Made a huge difference to have the wires behind the wall! I would love to try other products out!

Great that they come in a 2 pack. These work well, accommodate several wires and look nice. Easy to install and had no issues with them.

Easy to install easy to use I use this to run cables for my projector through the ceiling and down the wall

The openning is brushed so it hides the stuff behind id. Opening is big enough for most all plugs and wires. Easy to install bracket anywhere on wall (does not need to be next to a stud. In fact, better if not.

This worked like a charm, and allow me to run all my cables with different SIZED ends from behind my wall mounted TV down to the floor. VERY HAPPY

Quick install, don't be afraid to cut a few cm extra when cutting your drywall for fitment.

Installed a pair of these for a wall mount tv. Easy to cut in to the drywall and the tabs hold the trim snug to wall. Do not overtighten!

I used to run TV cable to equipment in closet and hide wiring.. Easy to set up, looks great. Def would buy again.

I have purchased many of these from different companies. These are great with the wall attachments, most have just a plate.

Used to route cables from back of big screen Tv and console below. Cut holes, installed frames, fished wires and covered all in less than 30 min. Don’t think I will have any trouble to add more wires on future if needed